Portage Electric Products - PEPI B - Model B - Switch, Thermal. NC SPST Self Resetting 50 Deg C.
- Buy 10 for $5.98 each and save 14%
Portage Electric Products - PEPI B - Model B - SPST Thermal Switch
Portage Electric Products, Inc.(Pepi ®) has been making bimetallic thermal control devices to make and break electrical circuits for over a half century.
The PEPI Model B is a creep action thermostat with a shunted type bimetal design. This lowers the current sensitivity and reduces the cycle rate of this device.
Status: Discontinued
Creep action thermostat/ thermal protector with shunt-type bimetal design for a higher contact rating.
Shunted bimetal construction where bimetallic element does not carry current
Gold diffused contacts for use in low voltage/low current applications
Slow make/slow break switch,Single Pole, Single Throw (SPST)
Fractional differential between opening and closing varies from 2 - 10 degress C, with Form Fitting Insulated sleeve
8 Amps/120 VAC resistive
6 Amps/120 VAC AC inductive
Normally Closed Self Resetting 50 Deg C.
Insulated enclosure is approximately 1.25" long x .27" wide x .22" thick
New Old Stock
Applications: This device has a higher contact rating making it well suited for motors, transformers, and appliance applications.
Additional Information: http://pepiusa.info/wp-content/uploads/2020/03/PEPI-How-To-Guide.pdf
| SKU | 3645 |
|---|---|
| Condition | NS - NEW SURPLUS |
| Part Number | PEPI B |
| Alternative Part Number | 49X+50, 02-2 |
Portage Electric Products - PEPI B - Model B - SPST Thermal Switch
Portage Electric Products, Inc.(Pepi ®) has been making bimetallic thermal control devices to make and break electrical circuits for over a half century.
The PEPI Model B is a creep action thermostat with a shunted type bimetal design. This lowers the current sensitivity and reduces the cycle rate of this device.
Status: Discontinued
Creep action thermostat/ thermal protector with shunt-type bimetal design for a higher contact rating.
Shunted bimetal construction where bimetallic element does not carry current
Gold diffused contacts for use in low voltage/low current applications
Slow make/slow break switch,Single Pole, Single Throw (SPST)
Fractional differential between opening and closing varies from 2 - 10 degress C, with Form Fitting Insulated sleeve
8 Amps/120 VAC resistive
6 Amps/120 VAC AC inductive
Normally Closed Self Resetting 50 Deg C.
Insulated enclosure is approximately 1.25" long x .27" wide x .22" thick
New Old Stock
Applications: This device has a higher contact rating making it well suited for motors, transformers, and appliance applications.
Additional Information: http://pepiusa.info/wp-content/uploads/2020/03/PEPI-How-To-Guide.pdf
