Audio

ASTATIC - T2M-914 Replacement Omnidirectional Audio, Microphone /Speaker.

Speaker / Microphone Matches Virtually any Transmitter.

Micro Switch with Positive Snap Action.

Rotable Spring Clip on Back.

Power Requirements: 3 to 12 VDC.  

Quality Electret Cartridge. 

Lightweight Durable Noryl Housing.

Dimensions: Approximately 2" wide x 3" high x 1.3" D.

Complete with 6 wire Neoprene coil cord, extends to 5-1/2 feet. 

Includes Hook-up Instructions. 

Electret microphones are a type of electrostatic capacitor-based microphone which eliminates the need for a polarizing power supply by using a permanently charged material.

Proudly Made in USA

 

Learn More

RCA Tac Tec Astatic - M1569029 Microphone.

Replacement Microphone for RCA Tac Tec 2-Way Radio Receivers. (Spec1476A).

Retractable Coiled Cord

7 Position Female Connector.

Spec. 1476A

Rare - New Old Stock - Vintage collectable

Made in Japan

Learn More

Audio, microphone. Head/Cover only with windscreen. Dimensions: overall 1.419" D x 2.374" high. Lower 1/2 is actually 1.288" long, windscreen is actually 1.120" long. Threaded ID 0.782" (22.1mm) diameter at base. Learn More

Audio, microphone. Cartridge, sensitivity -63(+/-)3dB. Dimensions: 10mm OD x 9mm. Learn More

ASTATIC - MC612 - Audio, Microphone Element.

Plastic mount for inside of mouthpiece.

Dynamic Cartridge for Buckeye 400 Microphone

Mouth piece not included.

Learn More

Transducer, audio. Electromagnetic. Dimensions: approximately 0.75 x 0.5 x 0.4". Yellow tape wrapped with 3 metal plates and 3 wires. Made for either Astatic Microphone or Conneaut Audio Devices. Learn More

ASTATIC - CAD1036A 435790000 PreAmp PCB.

The trusty MC33178 (and its quad version MC33179) is a reasonably powerful part (up to 80 mA source, 100 mA sink) with usable GBW and slew rate specs (5 MHz, 2 V/µs) that runs at a puny 420 µA per amplifier. It is particularly recommended for telephony applications, and indeed, a unity-gain follower driving 20 kHz at 2 Vpp into 600 ohms at 0.024% THD sounds hardly awe-inspiring. The npn-only AB output stage isn't too bad, but its symmetry is inherently limited, and it would have to be running at very small quiescent current. Performance should much improve with a few mA worth of Class A bias. The emitter follower on the sourcing side seems more trustworthy than the common emitter circuit on the sinking side, as it would always keep compensation capacitance well away from the outside world and seems to have slightly lower output impedance as well.

Uses MC33178P DIP (Discontinued)

White/Black/Red In and Out.

Dimensions: 1-11/16" x 1-7/16".

New Old Stock

Learn More

ASTATIC - 9000 - Power Module 9000 - Microphone In/Out

Astatic Corp was based on Conneaut Ohio for many years. Although they primarily produced microphones for voice-frequency communications work, they also made higher-fidelity models which are much less common. The company reorganized as Omnitronics LLC in 2000, and later combined CAD, Astatic and Omnitronics under the CAD Audio brand.

Model PM-9000 power module houses microphone electronics and features a superior low noise transformerless design for optimum frequency response. The PM-9000 power module also includes a switchable 12dB per octave high pass filter. The PM-9000 can be mounted either with 4 mounting screws or double-sided foam tape. 

Power Module - with High Pass Bypass / 12db Octave High Pass Switch

Miniature 3-pin male In / Mic XLR Male Out

Body: 5-1/2" L x 1-5/16" 5.5"Long Heatsinked Unit with mount x 2" Wide for Powering Lavilier Microphone

Made in the USA by Astatic

Bulk purchased Directly from Astatic. New Old Stock 

Learn More

Remote control unit. Mount: Rak 19". Dimensions: 19" long x 10-1/2" wide x 1.75" high. Powers up looks in good condition. Learn More